It can be quite annoying to lose hot water in your bathroom. It is not something anyone wants to do, especially if they have to take a cold shower. Your bathroom might not be getting hot water for one of several reasons. You should call your local emergency plumber in Glendale, CA to help diagnose the problem.
OLD PIPES
Your pipes or pipe lines may be to blame if your bathroom is the only one without hot water in your house. Even though you may not be aware, corrosion could cause water flow to stop, especially in older homes. Most pipes will be damaged from the inside, and this can be caused due to minerals in the water. This happens most often in areas with hard water. This corrosion can cause the water-flow stop, and pipes will likely need to replaced.
PIPE LINE
If your pipes appear to be in good condition and show no signs of corrosion, it could be your pipe line. If a water heater is installed on the opposite side of an area that receives hot water, it could be that the water is cooling too fast before reaching its destination.
A Glendale Emergency Plumber can inspect the pipe line and determine if it has been installed in the most efficient manner. Sometimes, a pipe line can travel through areas that are not well insulated or where temperatures are very low. Your plumber might suggest that you either install another water heater near the bathroom, or insulation your pipe line to solve this problem.
PIPE LEAK
It doesn’t appear that the problem is corroded pipes. What can we do now? Checking the pipes for leaks is the last step. A pipe leak can be easily identified by inspecting the pipes carefully and checking the water pressure.
A PARTIALLY CLOSED VALE
Valved pipe lines have the advantage of allowing you to shut off water flow when repairs are required. Pipe lines can sometimes be partially closed after a plumbing job. This is a common fix. Follow the pipe line connecting the bathroom and the water heater to locate the valve. Once you find it, simply open it again.
A temperature regulating valve is also installed by your local Glendale, CA Plumber. This regulates water’s temperature, making sure it doesn’t get too hot or too cold. This valve may be all you have to worry about.
CLOGGED FAUCET
If your faucet seems to lack hot water, it is likely that minerals have accumulated, making it clog. While cold water may seem to be flowing fine, it’s likely that the clog resists hot water flow because of higher temperatures which cause more mineral deposits.
Call your local Glendale Plumber if your home has had hard water in the past. Your plumber might find that your faucet is not working properly. A few adjustments should fix the problem.
WATER PRESSURE
The pressure of water can affect the hot water in your bathroom. This can be easily checked by using a pressure tester. This can be bypassed if the pressure coming out of the bathroom faucet is equal to the water heater’s pressure.
WATER HEATER
You may want to inspect the pipeline to determine the distance between the water heater and the bathroom. You may need to increase the size of your water heater to meet your home’s needs. This will cause hot water to stop flowing in certain areas.